|
|
|
 |
|
|
Choose the right alarms
There are smoke alarms available with different features and applications, so choosing the right alarm can be confusing. Some of the features to consider include:
- Power Source: Smoke alarms can be electrically powered, battery powered, or a combination of both. If you are installing an electrically powered alarm it is recommended that it have a battery back-up in case of power failures.
- Technology: most smoke alarms employ either ionization or photo-electric technology. Ionization alarms may respond slightly faster to flaming-type fires, while photo-electric alarms may be quicker at detecting slow, smouldering fires.
- Pause feature: Smoke alarms with a pause button are highly recommended as it permits the alarm to be temporarily silenced without disconnecting the power source.
Install in the proper locations
Smoke alarms must be installed on each storey of the home as well as outside sleeping areas. Because smoke rises, smoke alarms should be installed on the ceiling. If this is not possible, install the alarm high up on a wall. Always follow the manufacturer's instructions when installing smoke alarms.
Avoid putting smoke alarms too close to bathrooms, windows, ceiling fans and heating and cooking appliances.
Test smoke alarms monthly
Test your smoke alarms every month by using the test button on the alarm. When the test button is pressed, the alarm should sound. If it fails to sound, make sure that the battery is installed correctly or install a new battery. If the alarm still fails to sound, replace the smoke alarm with a new one.
Change the batteries at least once a year
The Canadian Association of Fire Chiefs recommends you change your smoke alarm batteries at least once a year. You should install a new battery at least once a year, or as recommended by the manufacturer. Install a new battery if the low-battery warning sounds or if the alarm fails to sound when tested.
Vacuum alarms annually
Dust can clog your smoke alarms. Battery-powered smoke alarms should be cleaned by opening the cover of the alarm and gently vacuuming the inside with a soft bristle brush.
For electrically-connected smoke alarms, first shut off the power to the unit, and then gently vacuum the outside vents of the alarm only. Turn the power back on and test the alarm.
Replace older smoke alarms
All smoke alarms wear out. If your alarms are more than 10 years old, replace them with new ones.
Handle nuisance alarms
Steam from the shower or cooking in the oven, stove or toaster can cause smoke alarms to activate. If these types of nuisance alarms occur, do not remove the battery. There are several options you can try to reduce nuisance alarms.
- Relocate the alarm. Sometimes moving the alarm just a few inches can make the difference.
- Install a smoke alarm with a pause button that will allow you to temporarily silence the alarm.
- Replace alarms located near kitchens with photo-electric types.
Plan your escape
Make sure that everyone knows the sound of the smoke alarm and what to do if it activates. Create an escape plan with the entire household and practice it. Make sure your plan identifies two ways out of each room, if possible, and a meeting place outside. Once outside, stay outside. Never re-enter a burning building. Call the fire department from a neighbours' home or cell phone.
Carbon Monoxide Detectors
The first line of defense against carbon monoxide is to make sure that all fuel-burning appliances operate properly. The second is a detector that works. Properly working carbon monoxide detectors can provide an early warning before the deadly gas builds up to a dangerous level.
|
|
|
 |
|
|
